minusOne
Crafty Poster

how to stamp on a dapped metal base?

Hello!

I want to stamp a dapped (concave) brass blank. Does anyone have a link or information on a concave block I can use to rest the base on while I stamp?

thanks in advance!

Jen
Translate to English There was a problem fetching the translation.
0 Likes
3 Replies

Re: how to stamp on a dapped metal base?

Could you use a dapping block or the dapping punch..getting concave and convex mixed up.
Translate to English There was a problem fetching the translation.
0 Likes
Reply
Loading...
Former_Member
Not applicable

Re: how to stamp on a dapped metal base?

concave is the inward curve.
so you could use the dapping block... if you are going to be doing stamping on a lot ot them the same size you could also hollow out on a wood base say a 2x4 in case you were worried about marring the dapping block
Translate to English There was a problem fetching the translation.
0 Likes
Reply
Loading...

Re: how to stamp on a dapped metal base?

the easiest thing to do is stamp than form, use a steel block and a wood or plastic dapping punch
Translate to English There was a problem fetching the translation.
0 Likes
Reply
Loading...
Reply
You must log in to join this conversation.
Remember that posts are subject to Etsy's Community Policy.